返回首页 | 加入收藏 | 关于我们 | 联系我们

欢迎光临济南广大铝业有限公司官网!

铝板生产企业 铝卷良心厂家

全国服务热线131-5601-1888
0531-87895188
当前位置:首页 » 济南铝板加工过程中应该注意哪些问题?

济南铝板加工过程中应该注意哪些问题?

文章出处:www.kewldewd.com 责任编辑:admin 发表时间:2015-1-12 18:12:52

1、济南铝板http://www.kewldewd.com/应存放于干燥通风处,且平放在平整的表面上,切勿踩踏、撞击,搬运济南铝板时应将板的四边同时抬起,严禁推拉、抽取,以免刮伤板面。
Jinan aluminum should be stored in a dry and ventilated place, and flat on a flat surface, do not stampede, impact, handling Jinan aluminum plate edges should be lifted at the same time, non-sliding, extraction, so as not to scratch the

plate surface.

2、济南铝板用开槽机或锣机开槽时,应使用半圆头式大于90度的铣刀,下刀既不要过深伤及铝板,也不要过浅使折边困难,应留有0.2-0.3MM厚塑料芯材连同铝板一起弯边,以增加强度和韧性,否则在弯边时铝板可能断裂或漆膜爆裂。
Jinan aluminum with a slot machine or a gong slotting machine should be used when more than 90 degrees button head type cutter, knife too deep hurt neither aluminum nor too shallow hemming difficulties should leave 0.2-0.3 MM thick

plastic core material together with the aluminum flanges together, to increase strength and toughness, otherwise the aluminum film may break or burst during crimping.

3、济南铝板弯边时需用力均匀,一次成型,不要反复弯折,否则铝板可能断裂,加工弧形应使用专用弯曲设备加工,徐徐用力,使板材逐步达到所需的曲面。切勿一次弯曲成型。
Jinan aluminum crimping takes force uniform, a shape, do not repeatedly bent aluminum might otherwise break, you should use special curved arc processing equipment, processing, slowly force, so that the sheet gradually achieve the

desired surface. Never once bent shape.

4、济南铝板http://www.kewldewd.com/同一型号而不同批次的板材可能存在色差,出售和使用不同批次板材时应增加比对色差之程序,无视觉色差时方可在同一平面使用,将同色铝塑板安装在同一平面时,流程方向应一致,否则可能造视觉色差。
Jinan aluminum different batches of the same model and color plates that may exist, the sale and use of different batches of the plate should be increased before use of color than the procedure, no visual color difference in the same

plane, the same color aluminum panels will be installed in the same plane , the flow direction should be consistent, otherwise it may create visual color.

 

此文关键字:济南铝板
日本三级香港三级人妇三,日本三级香港三级人妇三个月,日本三级香港三级人妇三欧美,日本三级香港三级人妇迅雷